Installation/Shower Seat
1. Site preparation: 1 x 8 backing boards are nailed in position between studs as shown. If access can be gained to the rear side of backing boards, plan seat installation using stainless steel bolts and washers.
NOTE: BEFORE DRILLING HOLES IN WALL, VERIFY THAT THERE ARE NO WATER PIPES OR ELECTRICAL WIRING CONCEALED BEHIND HOLE LOCATIONS.
2. Stainless steel wall anchors or lag screws may
be used in inaccessible areas. We suggest using
(4) 1/2” x 5-5/8” lags.
3. Drill holes through each vertical mounting face of the seat in locations as shown in Figure C. Hole size will be dependant on choice of mounting hardware.
4. Mark holes to be drilled using pre-drilled holes in seat as guides. Remove seat and drill holes in wall paneling. Wipe down wall and seat surfaces and locate seat as before. Secure the seat with mounting hardware. Apply silicone sealant along junction of seat and walls. Allow 24 hours of curing time before actual use.